• Make sure the gantry x axis (long side of the frame) is about 200 mm from its most negative

Starting and Calibrating ACME

If Kiewa has been rebooted, then the motion controller card will have been reset, which means that the gantry and linear stages will have to be recalibrated. Log in to kiewa, and then do the following:

• Run

       % /usr/bin/rtpatch
       

  This makes real-time Solaris extensions callable by regular users.

• Turn off the gantry/stage power by hitting the red button on the big power box (which connects to the controller rack through a long grey cable).

• Run

       % acmeboot
       

  The program will ask if you know what you're doing; enter "yes".

• Make sure the gantry x axis (long side of the frame) is about 200 mm from its most negative direction of travel. You can position it by hand by manually turning the axle (this is the long spline that runs across the gantry at the positive end of the x axis).

• Turn on the gantry/stage power by hitting the yellow button on the big power box. The pan/tilt head will move briefly as it autocalibrates; wait for this to stop.

• Run

       % acmehome
       

  This will move the gantry z first, then gantry y, then a few other joints in the test station, linear stage, and gantry. The process takes a few minutes, and should produce a bunch of output that looks like this:

       
            HOME: gantry-Z
            start: chan2: mode=1 setp=+00000041 curp=+00000041 maxerr=0000
            search:chan2: mode=1 setp=+00001229 curp=+00001323 maxerr=0000
            switch:chan2: mode=1 setp=-00104294 curp=-00104143 maxerr=0000
            zero:  chan2: mode=1 setp=-00099421 curp=-00099284 maxerr=0000
            home:  chan2: mode=1 setp=+00000000 curp=-00000023 maxerr=0121
            HOME: gantry-Y
            start: chan1: mode=1 setp=-00000001 curp=-00000001 maxerr=0000
            search:chan1: mode=1 setp=-00010005 curp=-00010005 maxerr=0000
  
             ...
      

  finishing with

            HeadCfg: max step: 1000, start: 1000, accel: 16, power: 20
            GPA
            Moving to joint values:
            -757.057   67.030 -150.385 -180.000   -0.000
      

  Sometimes, the calibration process will bail out prematurely, with a message like

            stageX not homed
      

  If this happens, try calibrating again. If the problem repeats, it may be that the amps in the controller rack need to be power cycled. To do this, halt kiewa first (kiewa is connected to the rack). The proper way to halt kiewa is with the /etc/halt command, but you need an admin to do this. Otherwise, run sync a few times from the keyboard and then power cycle the rack using the switch on the bottom panel. Do not power off kiewa separately (a sign on kiewa will remind you of this).

-- WolfgangHeidrich - 24 Nov 2005